Lectrosonics M2T

The audio inputs can be individually configured to be analog or Dante compatible. The analog input connectors are full-size XLR/TRS combo types for balanced line-level analog signals while the input preamp circuits use a special balanced amplifier with very high common mode rejection to minimize hum and noise. A Dante Ultimo interface via dual RJ45 connectors accepts Dante networked audio inputs and can cascade the digital stream to additional units via CAT6 cables. An additional RJ45 jack provides an Ethernet connection for programming and control via Wireless Designer software and a USB jack on the front panel allows for firmware updates. The transmitter features a full color, backlit LCD for high visibility in any environment, while the chassis is all-metal and can be racked singly or in pairs using included rack mount hardware.

• IEM (Wireless Monitor) with digital RF transmission

• 24-bit digital audio

• 2 independent stereo audio transmissions per 1/2 RV enclosure

• USB port for firmware updates

• Fully Dante compatible

• IR (infrared) port for fast setup

• Up to 50 mW per Rf carrier

• All metal housing

• Compatible with Wireless Designer Software

RF POWER OUTPUT:

• Two carriers; two audio channels each

• Power adjustable on each carrier to 10, 25 or 50 mW

ANTENNA OUTPUT:

2 x BNC sockets

OPERATING FREQUENCIES:

470.100 - 607.975 MHz

FREQUENCY SELECTION STEPS:

25 kHz

FREQUENCY STABILITY:

± 0.002%

MODULATION:

8 PSK

EMISSION DESIGNATOR:

200KG7E

SPURIOUS RADIATION:

Compliant with ETSI EN 300 422-1

EQUIVALENT INPUT NOISE:

-128 dBV

LATENCY (OVERALL SYSTEM):

• Digital Source: 1.0 ms plus Dante network

• Analog Source: