RME LNI-2 DC Filter

RME presents the LNI-2 DC, a spectacular active DC filter, compact and portable, milled from a solid block of aluminum. The LNI-2 DC provides isolation, regulation and filtering of output signals from any 12 volt DC power source, enabling a remarkable improvement in DC voltage stability while providing an ultra-clean 12V power source. This results in an enhanced audio signal and sound quality avoiding humming, buzzing and other noises that can be caused by power supplies or dirty mains power.

DC INPUT:

Input voltage range: 9 " 18 V DC

Polarity: Center +, Outside -

Connector: 2.1x5.5mm, lockable or normal

Power consumption idle: 0.7 Watt

Power consumption typical, 12V input, 2 A load: 31 Watts

DC OUTPUT ΜFILTER:

Output voltage: 12.0 V

Continuous output current: 2.0 A

Continuous output power: 24 Watt

Maximum output current: 3.0 A

Noise @ 0 - 3 A, AES17: < 2 μV, < 1 μV A-weighted

Noise @ 0 - 3 A, 100 kHz bandwidth: <3 μV, < 2 μV A-weighted

Output impedance including cable: 0.012 Ohm

Load Regulation (0/1/2 A): 0.20 %

Overload protection: > 3.0 A

Overheating protection: > 80 C (176 F)

Undervoltage detection: < 9.0 V

Short circuit current (LED red): <0.1 A

Filter (decoupling) efficiency, 10 Hz " 1 kHz: >110 dB

Filter (decoupling) efficiency, 1 kHz - 200 kHz: >70 dB

GENERAL:

Dimensions (WxHxD): 80 x 30 x 123 mm, 3.15" x 1.18" x 4.84"

Weight: 605 g (1.33 lbs)

Temperature range: +5 C up to +40 Celsius (41 F up to 104 F)

Relative humidity: < 75%, not condensing

PACKAGE CONTENTS:

LNI-2 DC

DC Sensor connection cable with lockable DC plug 2.1x5.5 mm, 1 m

DC Sensor connection cable with DC plug 2.1x5.5 mm, 1 m